Supplier-derived AI reference illustration. It does not establish the geometry, dimensions or identity of this requested MXL configuration.
Review the requested measurement envelope.
This model page is an engineering request sheet. The identifier and target envelope do not establish a released stock item, approved dimensional drawing or verified replacement.
Review item
Requested MXL configuration
Measured components
3-Axis Force [Fx, Fy, Fz]
Force capacity target
Fx/Fy about 11.1 kN; Fz about 22.2 kN requested
Moment capacity target
Not measured; review offset moments
MXL dimensions and mounting
Drawing review required
Electrical interface
Per-axis bridge input/output resistance, excitation, sensitivity and pinout to confirm
Performance evidence
Crosstalk, combined loads, uncertainty, temperature behavior and safe/ultimate limits to confirm
Resolve the details specific to this configuration.
Preserve the full usable bore after cables, inserts and strain relief are installed.
Check separate bridge resistance and sensitivity on every axis; mixed-bridge configurations need independent scaling.
Review flange flatness, fastener engagement, combined loads and environmental sealing in the final drawing.
Published third-party reference / separate from MXL approval
FUTEK MTA600
Ø126.5 × 88.9 mm; Ø43.7 mm through bore
Fx/Fy 350 Ω, 1.50 mV/V; Fz 700 Ω, 0.75 mV/V; maximum excitation 18 V
DB15 female CC9; independent excitation/signal pairs for each measured axis
FI1469; current linked PDF has 3 pages including terms · Reviewed 2026-10-31. Manufacturer reference facts only. Do not transfer its geometry, material, limits or calibration to an MXL configuration.
Confirm independent component ranges and the worst simultaneous load event.
Approve both mounting faces, clearances, fastener engagement and the cable route.
Match excitation, bridge loading, nominal sensitivity and controller input range.
Agree on calibration evidence, useful bandwidth, timing and environmental requirements.
Send the actual original-model revision for replacement work. CAD and lead time are confirmed against the approved configuration rather than inferred from the reference name.
Compare other MXL-3H configurations.
Requested configurations — approval and quotation required
